1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
|
/* SPDX-License-Identifier: GPL-2.0+ */
/*
* Copyright (C) 2007 Freescale Semiconductor, Inc.
* Kevin Lam <kevin.lam@freescale.com>
* Joe D'Abbraccio <joe.d'abbraccio@freescale.com>
*/
#ifndef __CONFIG_H
#define __CONFIG_H
#include <linux/stringify.h>
/*
* High Level Configuration Options
*/
/* System performance - define the value i.e. CONFIG_SYS_XXX
*/
/* System Clock Configuration Register */
#define CFG_SYS_SCCR_TSEC1CM 1 /* eTSEC1 clock mode (0-3) */
#define CFG_SYS_SCCR_TSEC2CM 1 /* eTSEC2 clock mode (0-3) */
#define CFG_SYS_SCCR_SATACM SCCR_SATACM_2 /* SATA1-4 clock mode (0-3) */
/*
* System IO Config
*/
#define CFG_SYS_SICRH 0x08200000
#define CFG_SYS_SICRL 0x00000000
/*
* Output Buffer Impedance
*/
#define CFG_SYS_OBIR 0x30100000
/*
* Device configurations
*/
/* Vitesse 7385 */
#ifdef CONFIG_VSC7385_ENET
/* The flash address and size of the VSC7385 firmware image */
#define CFG_VSC7385_IMAGE 0xFE7FE000
#define CFG_VSC7385_IMAGE_SIZE 8192
#endif
/*
* DDR Setup
*/
#define CFG_SYS_SDRAM_BASE 0x00000000 /* DDR is system memory */
#define CFG_SYS_DDR_SDRAM_CLK_CNTL 0x03000000
#define CFG_SYS_DDRCDR_VALUE (DDRCDR_DHC_EN | DDRCDR_ODT | DDRCDR_Q_DRN)
/*
* Manually set up DDR parameters
*/
#define CFG_SYS_SDRAM_SIZE 0x10000000 /* 256 MiB */
#define CFG_SYS_DDR_CS0_BNDS 0x0000000f
#define CFG_SYS_DDR_CS0_CONFIG (CSCONFIG_EN \
| CSCONFIG_ODT_WR_ONLY_CURRENT \
| CSCONFIG_ROW_BIT_13 \
| CSCONFIG_COL_BIT_10)
#define CFG_SYS_DDR_TIMING_3 0x00000000
#define CFG_SYS_DDR_TIMING_0 ((0 << TIMING_CFG0_RWT_SHIFT) \
| (0 << TIMING_CFG0_WRT_SHIFT) \
| (0 << TIMING_CFG0_RRT_SHIFT) \
| (0 << TIMING_CFG0_WWT_SHIFT) \
| (2 << TIMING_CFG0_ACT_PD_EXIT_SHIFT) \
| (6 << TIMING_CFG0_PRE_PD_EXIT_SHIFT) \
| (8 << TIMING_CFG0_ODT_PD_EXIT_SHIFT) \
| (2 << TIMING_CFG0_MRS_CYC_SHIFT))
/* 0x00260802 */ /* DDR400 */
#define CFG_SYS_DDR_TIMING_1 ((3 << TIMING_CFG1_PRETOACT_SHIFT) \
| (9 << TIMING_CFG1_ACTTOPRE_SHIFT) \
| (3 << TIMING_CFG1_ACTTORW_SHIFT) \
| (7 << TIMING_CFG1_CASLAT_SHIFT) \
| (13 << TIMING_CFG1_REFREC_SHIFT) \
| (3 << TIMING_CFG1_WRREC_SHIFT) \
| (2 << TIMING_CFG1_ACTTOACT_SHIFT) \
| (2 << TIMING_CFG1_WRTORD_SHIFT))
/* 0x3937d322 */
#define CFG_SYS_DDR_TIMING_2 ((0 << TIMING_CFG2_ADD_LAT_SHIFT) \
| (5 << TIMING_CFG2_CPO_SHIFT) \
| (3 << TIMING_CFG2_WR_LAT_DELAY_SHIFT) \
| (2 << TIMING_CFG2_RD_TO_PRE_SHIFT) \
| (3 << TIMING_CFG2_WR_DATA_DELAY_SHIFT) \
| (3 << TIMING_CFG2_CKE_PLS_SHIFT) \
| (8 << TIMING_CFG2_FOUR_ACT_SHIFT))
/* 0x02984cc8 */
#define CFG_SYS_DDR_INTERVAL ((1024 << SDRAM_INTERVAL_REFINT_SHIFT) \
| (0 << SDRAM_INTERVAL_BSTOPRE_SHIFT))
/* 0x06090100 */
#define CFG_SYS_DDR_SDRAM_CFG (SDRAM_CFG_SREN \
| SDRAM_CFG_SDRAM_TYPE_DDR2)
/* 0x43000000 */
#define CFG_SYS_DDR_SDRAM_CFG2 0x00001000 /* 1 posted refresh */
#define CFG_SYS_DDR_MODE ((0x0406 << SDRAM_MODE_ESD_SHIFT) \
| (0x0442 << SDRAM_MODE_SD_SHIFT))
/* 0x04400442 */ /* DDR400 */
#define CFG_SYS_DDR_MODE2 0x00000000
/*
* Memory test
*/
#undef CFG_SYS_DRAM_TEST /* memory test, takes time */
/*
* The reserved memory
*/
/*
* Initial RAM Base Address Setup
*/
#define CFG_SYS_INIT_RAM_ADDR 0xE6000000 /* Initial RAM address */
#define CFG_SYS_INIT_RAM_SIZE 0x1000 /* Size of used area in RAM */
/*
* FLASH on the Local Bus
*/
#define CFG_SYS_FLASH_BASE 0xFE000000 /* FLASH base address */
#define CFG_SYS_FLASH_SIZE 8 /* max FLASH size is 32M */
/*
* NAND Flash on the Local Bus
*/
#define CFG_SYS_NAND_BASE 0xE0600000
/* Vitesse 7385 */
#define CFG_SYS_VSC7385_BASE 0xF0000000
/*
* Serial Port
*/
#if !CONFIG_IS_ENABLED(DM_SERIAL) && !CONFIG_IS_ENABLED(DM_CLK)
#define CFG_SYS_NS16550_CLK get_bus_freq(0)
#endif
#define CFG_SYS_BAUDRATE_TABLE \
{300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 115200}
#define CFG_SYS_NS16550_COM1 (CONFIG_SYS_IMMR+0x4500)
#define CFG_SYS_NS16550_COM2 (CONFIG_SYS_IMMR+0x4600)
/* SERDES */
#define CFG_FSL_SERDES1 0xe3000
#define CFG_FSL_SERDES2 0xe3100
/* I2C */
#define CFG_SYS_I2C_NOPROBES { {0, 0x51} }
/*
* Config on-board RTC
*/
#define CFG_SYS_I2C_RTC_ADDR 0x68 /* at address 0x68 */
/*
* General PCI
* Addresses are mapped 1-1.
*/
#define CFG_SYS_PCIE1_CFG_BASE 0xA0000000
#define CFG_SYS_PCIE1_CFG_SIZE 0x08000000
#define CFG_SYS_PCIE1_MEM_PHYS 0xA8000000
#define CFG_SYS_PCIE1_IO_PHYS 0xB8000000
#define CFG_SYS_PCIE2_CFG_BASE 0xC0000000
#define CFG_SYS_PCIE2_CFG_SIZE 0x08000000
#define CFG_SYS_PCIE2_MEM_PHYS 0xC8000000
#define CFG_SYS_PCIE2_IO_PHYS 0xD8000000
#ifdef CONFIG_MMC
#define CFG_SYS_FSL_ESDHC_ADDR CFG_SYS_MPC83xx_ESDHC_ADDR
#endif
/*
* Miscellaneous configurable options
*/
/*
* For booting Linux, the board info and command line data
* have to be in the first 256 MB of memory, since this is
* the maximum mapped by the Linux kernel during initialization.
*/
#define CFG_SYS_BOOTMAPSZ (256 << 20) /* Initial Memory map for Linux */
/*
* Environment Configuration
*/
#define FDTFILE "mpc8379_rdb.dtb"
#define CFG_EXTRA_ENV_SETTINGS \
"netdev=eth1\0" \
"uboot=" CONFIG_UBOOTPATH "\0" \
"tftpflash=tftp $loadaddr $uboot;" \
"protect off " __stringify(CONFIG_TEXT_BASE) \
" +$filesize; " \
"erase " __stringify(CONFIG_TEXT_BASE) \
" +$filesize; " \
"cp.b $loadaddr " __stringify(CONFIG_TEXT_BASE) \
" $filesize; " \
"protect on " __stringify(CONFIG_TEXT_BASE) \
" +$filesize; " \
"cmp.b $loadaddr " __stringify(CONFIG_TEXT_BASE) \
" $filesize\0" \
"fdtaddr=780000\0" \
"fdtfile=" FDTFILE "\0" \
"ramdiskaddr=1000000\0" \
"ramdiskfile=rootfs.ext2.gz.uboot\0" \
"console=ttyS0\0" \
"setbootargs=setenv bootargs " \
"root=$rootdev rw console=$console,$baudrate $othbootargs\0" \
"setipargs=setenv bootargs nfsroot=$serverip:$rootpath " \
"ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname:" \
"$netdev:off " \
"root=$rootdev rw console=$console,$baudrate $othbootargs\0"
#endif /* __CONFIG_H */
|